A flake system runs $3 to $8 per square foot and polyaspartic $5 to $9, and a two-car garage usually lands between $2,500 and $6,000 installed. Preparation is what decides whether the floor lasts 12 to 15 years or peels inside two. Tell us about the slab and we match you with local crews that quote in writing.
Tell us what you need and we route it to local epoxy flooring contractors who do this work. Free, no obligation.
A Reno garage slab works harder than any other floor in the house: summer surface heat, winter ice-melt brine, and a car that parks in the same two spots every night.
A basement floor in Reno is a moisture question before it is a finish question, and the answer is decided by the slab, not by the coating.
A commercial floor is bought in hours of uptime, not in square feet of resin.
Metallic epoxy is a design floor built on an engineering system: the swirl is the topcoat's business, the bond is the slab's.
Polyaspartic is the coating that made the one-day floor possible, and it is the layer that decides how a Reno floor ages under a high-desert sun.
Raw concrete is a working surface, not a finished one, and sealing it is the cheapest way to stop dusting, staining and moisture at the surface.
| Job | Published range |
|---|---|
| Flake system, per sq ft | $3 - $8 |
| Polyaspartic, per sq ft | $5 - $9 |
| Two-car garage, installed | $2,500 - $6,000 |
| Professional install, full range | $5.00 - $15.00 per sq ft |
| Retail DIY kit | $60 - $160 |
| DIY maintenance over 12 years | $720 - $1,920 |
| Repair cost over 12 years, professional system | $0 |
Figures are the published ranges carried over from the source pack, unrounded. Full cost guide.
Reno sits in the Truckee Meadows at roughly 4,500 ft, and the ground under it is not uniform. USDA-NRCS maps the Reno series on the alluvial fans, with a duripan 50 to 100 cm down that holds water, and the Truckee series on the old flood plain, which is poorly drained with a seasonally high water table. Where a slab sits on ground like that, vapour moves up through the concrete even though the air here is dry - average July relative humidity in Reno is around 30%. Add the swing from a 108 F record high to a -16 F record low, and the usual causes of failure are moisture, preparation and thermal cycling rather than the resin brand.
Start with the slab moisture check and the measurement calculator, then run the cost estimator, the system selector and the quote comparison before you call anyone. Twenty tools, no sign-up.
Open all 20 tools → | System advisor
The epoxy flooring questions Reno homeowners ask most.